
分组无线电(packet radio)是业余无线电圈颇具乐趣的玩法。当年爱好者们曾用 Heathkit HK-21 Pocket Packet 这样的设备在电波上传数据。Heathkit 早已淡出市场,而业余无线电玩家 btech 如今用现代硬件复刻了这台经典设备。
这个项目被命名为 Pocket Pico,和它致敬的原机一样,是一台业余分组无线电的终端节点控制器(TNC)。它直接运行真正的 HK-21 原版固件:树莓派 Pico 通过 Z80 处理器模拟器执行原代码,同时用这颗微控制器完成 1200 波特 Bell 202 音频信号的调制与解调,省去了专用调制解调器芯片。
由于运行的是与 HK-21 完全相同的固件,Pocket Pico 可以搭配大量老式分组无线电软件使用,完整支持 APRS 与 AX.25 Level 2 协议,还内置了个人公告板系统(BBS),供其他电台留言。
对于想入门分组无线电的玩家来说,这是一个兼顾情怀与实用性的开源方案,也展示了 RP2040 这类廉价微控制器在"软硬结合"复古计算项目中的潜力。
本文来源:https://hackaday.com/2026/09/25/pi-pico-recreates-the-heathkit-pocket-packet/
若有版权问题,请来信告知:13951431913#139.com 或在右方提交评论。
Packet radio is a fun niche in amateur radio. Enthusiasts once used devices like the Heathkit HK-21 Pocket Packet to transmit data over the airwaves. Heathkit has long since left the market, and amateur radio hobbyist btech has now recreated this classic device with modern hardware.
The project is called Pocket Pico, and like the original it honors, it is a terminal node controller (TNC) for amateur packet radio. It directly runs the real HK-21 original firmware: the Raspberry Pi Pico emulates a Z80 processor to execute the original code, while the microcontroller also handles the modulation and demodulation of the 1200 baud Bell 202 audio signal, eliminating the need for a dedicated modem chip.
Because it runs the exact same firmware as the HK-21, Pocket Pico works with a wide range of legacy packet radio software, fully supports the APRS and AX.25 Level 2 protocols, and includes a built-in personal bulletin board system (BBS) for other stations to leave messages.
For those looking to get into packet radio, this is an open-source solution that combines nostalgia with practicality, and it also demonstrates the potential of inexpensive microcontrollers like the RP2040 in "hardware-software hybrid" retrocomputing projects.
