IT之家 9 月 29 日消息,科技媒体 NeoWin 于 9 月 27 日发布博文,报道称过去数月时间里,陆续有使用者反馈 Windows 11 开机使用约 3~5 分钟后浮现卡死情况,初步调查指向默认的“安全启动更新计划任务”。
该媒体指出受影响使用者通常在开机约 3~5 分钟后卡死,部分使用者测试断网情况下使用,没有复现该故障;但在联网状态下,这种情况更加容易复现。
使用者借助任务管理器和事件查看器排查后,将难题指向“安全启动更新计划任务”(Secure-Boot-Update scheduled task)。该任务会在设备联网后检查安全启动更新,因而容易被误认为网络连接引发故障。IT之家附上相关截图如下:
微软故障排除文档表明,该任务默认每 12 小时运行一次。任务会读取名为“AvailableUpdates”的位掩码,并按固定顺序处理待完成的安全启动更新。操作成功后,对应状态位会被清除。
如果更新操作失败,Windows 会记录事件并保留对应状态位。任务下次运行时会再次尝试相同操作。微软确认,固件或平台级难题可能导致安全启动服务停滞,甚至持续重试。
使用者可在管理员 PowerShell 中运行以下命令查看任务状态:
schtasks.exe /Query /TN "\Microsoft\Windows\PI\Secure-Boot-Update" /FO LIST /V
本文来源:https://www.ithome.com/1/008/229.htm
若有版权问题,请来信告知:13951431913#139.com 或在右方提交评论。
IT之家 reported on September 29 that tech media NeoWin published a blog post on September 27, stating that over the past few months, users have successively reported Windows 11 freezing about 3–5 minutes after boot, and preliminary investigation points to the default "Security Boot Update scheduled task".
The media noted that affected users typically experience freezing about 3–5 minutes after boot. Some users tested offline usage and did not reproduce the fault; however, when connected to the network, the issue was easier to reproduce.
After troubleshooting with Task Manager and Event Viewer, users pointed the finger at the "Secure-Boot-Update scheduled task". This task checks for secure boot updates after the device connects to the network, so it is easily mistaken for a network-related fault. IT之家 attaches relevant screenshots below:
Microsoft's troubleshooting documentation indicates that this task runs every 12 hours by default. The task reads a bitmask named "AvailableUpdates" and processes pending secure boot updates in a fixed order. After a successful operation, the corresponding status bit is cleared.
If the update operation fails, Windows logs the event and retains the corresponding status bit. The task will retry the same operation on its next run. Microsoft confirmed that firmware or platform-level issues may cause the Secure Boot service to stall, or even keep retrying continuously.
Users can run the following command in an administrator PowerShell to view the task status:



