《电动汽车动力蓄电池在役检测试验方法》国标发布 2027 年 3 月起实施China Publishes National Standard for In-Service Testing of EV Traction Batteries, Effective March 2027


AI free token/AI免费积分

IT之家 10 月 21 日消息,市面监管总局(国家标准委)今日发布《电动汽车动力蓄电池在役检测试验方法》(GB/T 48100—2026)。

该标准于 2026 年 8 月 28 日批准发布,将于 2027 年 3 月 1 日正式实施。标准适用于电动汽车在役动力蓄电池检测,覆盖电池隐患排查、二手车交易与能力检测等应用情形,规定了服役状态下的通用测试条件,明确外观、气密性、绝缘、热管理平台等检测项目,并给出可用容量保持率、电压与内阻一致性的估算方式。

《电动汽车动力蓄电池在役检测试验方法》国标发布 2027 年 3 月起实施

这份标准填补的空白在于“方法不统一”。在此之前,动力电池的在役检测并非没有实践,但检测条件、流程和结果记录方式缺乏统一规范,不同机构对同一块电池可能给出可比性有限的结论。

此次新标准将检测项目区分为“测试”与“估算”两类:外观、气密性、绝缘、热管理属于可现场执行的测试项目,可用容量保持率和一致性则属于基于测试数据的估算项目。这一框架承认了在役检测的现实约束 —— 车辆不能像实验室电芯那样被拆解和循环测试,检测必须在整车、在用状态下完成,因而结果的可比性依赖于对测试条件和估算方法的统一约定。

该标准与已有的年检制度形成衔接而非替代。2025 年 3 月 1 日实施的《新能源汽车运行安全表现检验规程》(GB/T 44500—2024)已将动力蓄电池安全纳入年检项目,要求检测站用不小于 60kW 的直流设备对车辆持续充电,监测电池温度与电压异常,磷酸铁锂电池充电最高温度不得超过 65℃、三元锂电池不得超过 60℃。GB/T 48100—2026 给出的则是一套更完整的在役检测方法,其应用情形不限于年检,还明确指向隐患排查和二手车交易中的能力检测。年检回答的是“能否合法上路”,在役检测方法回答的是“电池当前处于什么状态”。

IT之家注意到,起草单位主要涵盖中国汽车工艺研究中心有限公司、厦门金龙联合汽车工业有限公司、中汽软件(深圳)有限公司、宁德时代新能源科技股份有限公司、想用车(大连)新能源科技有限公司、北京查博士科技股份有限公司、北京懂车族科技有限公司(懂车帝主体企业)、天津职业工艺师范大学、岚图汽车科技股份有限公司、比亚迪汽车工业有限公司、浙江吉利控股集团有限公司、深圳市比亚迪锂电池有限公司、上海启源芯动力科技有限公司。

本文来源:https://www.ithome.com/1/016/111.htm
若有版权问题,请来信告知:13951431913#139.com 或在右方提交评论。

IT House reported on October 21 that the General Administration of Municipal Supervision (National Standards Committee) today released the "Test Method for In-service Testing of Electric Vehicle Power Batteries" (GB/T 48100—2026).

The standard was approved for publication on 28 August 2026 and will be formally implemented on 1 March 2027. The standard is applicable to the testing of in-service power batteries for electric vehicles, covering applications such as battery hazard investigation, used car trading and capability testing, specifying the general test conditions in the service state, clarifying the testing items such as appearance, air tightness, insulation, and thermal management platform, and giving the estimation methods for the available capacity retention rate, voltage and internal resistance consistency.

The standard fills a gap in the “inconsistent approach”. Prior to this, the in-service testing of power batteries was not without practice, but the testing conditions, processes, and results recording methods lacked uniform specifications. Different institutions may give limited comparability conclusions for the same battery.

The new standard divides the test items into two categories: "test" and "estimate": appearance, air tightness, insulation, and thermal management belong to field-executable test items, and the usable capacity retention rate and consistency belong to the estimation items based on test data. This framework recognizes the practical constraints of in-service testing - the vehicle cannot be disassembled and cycled like a laboratory cell, and testing must be completed in the vehicle and in use, so the comparability of results depends on a unified agreement on test conditions and estimation methods.

This standard is in line with the existing annual inspection system and is not a substitute. The "Procedure for Inspection of Operation Safety Performance of New Energy Vehicles" (GB/T 44500-2024) implemented on March 1, 2025 has included the safety of power batteries in the annual inspection project, requiring testing stations to continuously charge vehicles with DC equipment of not less than 60kW to monitor battery temperature and voltage abnormalities. The maximum temperature of charging lithium iron phosphate batteries shall not exceed 65 ℃ and ternary lithium batteries shall not exceed 60 ℃. GB/T 48100—2026 gives a more complete set of in-service testing methods, the application of which is not limited to annual inspection, but also clearly points to the detection of hidden dangers and capacity testing in used car transactions. The annual inspection answers "whether it can legally go on the road", and the in-service detection method answers "what state the battery is currently in".

IT House noted that the drafting units mainly included China Automobile Technology Research Center Co., Ltd., Xiamen Jinlong United Automobile Industry Co., Ltd., China Automobile Software (Shenzhen) Co., Ltd., Ningde Times New Energy Technology Co., Ltd., Xiangyong Vehicle (Dalian) New Energy Technology Co., Ltd., Beijing Dr. Cha Technology Co., Ltd., Beijing Know-Car Technology Co., Ltd. (Know-Car Emperor Main Enterprise), Tianjin Vocational Technology Normal University, Lantu Automobile Technology Co., Ltd., BYD Automobile Industry Co., Ltd., Zhejiang Geely Holding Group Co., Ltd., Shenzhen BYD Lithium Battery Co., Ltd., Shanghai Qiyuanxin Power Technology Co., Ltd.

This article is from: https://www.ithome.com/1/016/111.htm For copyright issues, please write to: 13951431913#139.com or submit a review on the right.

China Publishes National Standard for In-Service Testing of EV Traction Batteries, Effective March 2027

暂无评论,快来发表第一条评论吧!No comments yet. Be the first!

📮 需求咨询📮 Inquiry