
尽管电子纸显示屏以低功耗和只要未受物理损坏便几乎能永久耐用而闻名,但近期为了以 30 FPS 这样的帧率驱动更廉价的电子纸显示屏以获得不错的黑白游戏体验所做出的努力,确实引发了一些疑问。首先是这对此类显示屏的功耗有何影响,其次是这是否会让显示屏很快报废。为了对此进行探究,[Bo Made It] 进行了一些实验。
本次测试的对象是一块 Waveshare ESP32-S3-ePaper 开发板,该板此前曾被演示以 30 FPS 运行 Game Boy 模拟器。在此软件运行时,该板平均消耗约 115 mA 电流,这意味着该设备的 400 mAh 电池大约会在 3.5 小时内耗尽。在此基础上,关键是要分离出显示屏本身的功耗,其中系统在不更新显示屏的情况下耗电约为 90 mA。
当在不向屏幕渲染的情况下运行灰度模式的帧计算时,电流消耗升至 107.6 mA,因此在 30 FPS 灰度模式下,显示屏本身的耗电仅约为 7.4 mA,这一数值微乎其微。显然,即使在较高帧率下,电子纸的低功耗特性依然成立。
至于寿命,某份数据手册给出的典型使用寿命为一百万次更新。这相当于在 30 FPS 下运行约 9.3 小时,但这假定每次均为全屏刷新。由于智能驱动程序仅更新发生变化的像素,使用时间显然会更长,但问题是能长多少,以及性能劣化会呈现何种状态?
在运行了 216 万帧包含重复图案的自定义耐久性测试后,出现了一些残影,但重复刷新又使其消失了。这意味着,就目前而言,在电子纸制造商提供的(毫无疑问较为保守的)限制范围内,尚未检测到永久性损坏。
值得注意的是,Waveshare 官方也建议不要在其设备上运行此类高帧率应用,这意味着这绝对是一次大型的长期耐用性实验。如果确实发生了损坏,显然这将不属于任何保修的范畴。
本文来源:https://hackaday.com/2026/10/28/does-running-an-e-paper-display-at-30-fps-destroy-it/
若有版权问题,请来信告知:13951431913#139.com 或在右方提交评论。
Although e-paper displays are famous for being low-power and lasting essentially forever if not damaged physically, the recent push to drive even cheaper e-paper displays at a framerate like 30 FPS for a decent monochrome gaming experience does raise a few questions. The first being what this does to the power usage of these displays, and the second whether this will wear out the display in short order. To investigate this, [Bo Made It] set up a few experiments .
Subject of this test was a Waveshare ESP32-S3-ePaper board, which had previously been demonstrated running a Game Boy emulator at 30 FPS. With this software running, the board consumed on average about 115 mA, which would run down the device’s 400 mAh battery in about 3.5 hours. From here key was to isolate the power consumption of the display itself, with the system minus the display updates consuming about 90 mA.
Running the frame calculations for the greyscale mode without rendering to the screen pushed that up to 107.6 mA, with even in the 30 FPS greyscale mode the display thus only consuming about 7.4 mA, which is vanishingly small. Clearly the low-power claims of e-paper remain intact even at higher framerates.
As for lifespan, one datasheet gives the typical lifespan as one million updates. This would translate to about 9.3 hours at 30 FPS, though that assumes a full display refresh. Since a smart driver only updates changed pixels, obviously this will be longer, but the question is how much longer, and what will degradation look like?

After running 2.16 million frames of a custom endurance test featuring repeating patterns, some ghosting was apparent, but repeated refreshing made this go away again. This means that so far no permanent damage has been detected within the no doubt conservative limit provided by e-paper manufacturers.
It should be noted that Waveshare itself also recommends against running such high-FPS applications on their device, meaning that this is definitely one big longevity experiment. If actual damage occurs, this means that obviously this won’t be covered under any warranty.